Unlinked Design Table

Discussion created by Guest on Jul 7, 2006

Like • Show 0 Likes0
Comment • 3

Yes I tried to restart solidworks and reboot my computer. The table is internal to the drawing. I just finished a complete reinstall and that seemed to have fixed the problem. at least until next time. I just wonder if there is anything else that can be done should this happen again.

Outcomes

3 Replies

Guest Jul 7, 2006 3:01 PM
Did you try closing and restarting SolidWorks? Did you reboot your computer and re-open SolidWorks? Is the design internal or external?
EditDeleteLike • Show 0 Likes0
Actions
Guest Jul 7, 2006 3:01 PM
Upon closing and reopening a drawing or solidworks I get the error "Failed to connect link may be broken" when I try to edit or insert a deign table. Solidworks then crashes within a few minute. Anyone have a clue as to the cause?
EditDeleteLike • Show 0 Likes0
Actions
Guest Jul 7, 2006 3:01 PM
Guess I am not current on design tables. I did not know that a DT can be put inside a drawing. I thought design tables were in models? Or did you mean that you inserted the design table from the model into the drawing?
EditDeleteLike • Show 0 Likes0
Actions

Unlinked Design Table

Outcomes

Related Content

Recommended Content