i try to model a steel making plant in 3d. i adding the part and sub assembly in main assembly.and main assembly is very large so i can't work on it.
is there a way that can decrese the capacity of main assembly?
What are your system specs?
Are you using the Large Assembly Mode with all performance saving options?
Create simplified configs of the sub-assys to use when working on the main assy.
Use SpeedPak sub-assys
Where possible, suppress sub-assys which aren't needed.
All of Kevin's suggestions are good ones, Taghi. What is happening when you try to work on the plant assembly. Are you getting an error message when you open it, does it fail to load or does it simply run so slow that you can't get anything done in the time you have?
My advice is too read this book:
my systems spec :
Workstation : Hp Workstation Z800 1110W--- Processor : Intel Xeon X5675( 3.06GHZ 12MB 6Core) ----Memory : 12 GB DDR3 1333MHZ ECC---- Graphic : Nvidia Quadro 4000 2GB DDR5--- OS Storage : Intel 120GB SSD 330 Series---Storage : HP 1TB Stata 7.2K 3.5---
i havent any error message but my system become very slow
Retrieving data ...