AnsweredAssumed Answered

Possible to use a DT at assembly level and write configs back to parts?

Question asked by Bill Lacey on Sep 20, 2012
Latest reply on Oct 5, 2016 by Arpad Kormendy

I have an assembly with a few parts in it that I would like to control via a design table. This assembly will require multiple configurations that I would like to create using the design table, but in order for it to show up properly on a drawing the configurations need to exist at the part level as well. I know that when I manually add a configuration I can select which parts I want to have the same configuration created in, but this cannot be done through the design table (at least as far I know).

 

Is there a macro that can handle this, or will I be forever limited to manually creating the configurations?

Outcomes