There is one client computer (so far) experiencing a problem that keep files from being checked into the EPDM vault. I have attached an image of the warning to this thread.
I have:
Using: SolidWorks 2012, SP4
Enterprise PDM 2012, SP2
This has the potantial to become a big problem if files can not be checked back into the vault.
Any suggestions on where to look for a solution?
Raghavendra,
I have no problem opening the drawing files in SolidWorks. I can open as "read-only" or check the file out. The trouble occurs when I am ready to check the file back into the vault. It is at that monent that I receive the " unknown file format" error. I am not permitted to check the file into the vault as a result of this error. The file history will not show any problems as it does not record check-out events, only check in events and since I can not check the file in..............no check in event.
And this issue seems to be present on one client computer at this time, so I believe that there must be some knind of conflict outside of SW & EPDM that may be causing the problem.
David,
Did this computer had Contributor client earlier ??? What does the client log say ?
The computer has always been set as an "editor" in Enterprise PDM.
Hello David,
Intresting error ? Were you able to open the SolidWorks Drawing file? Can you please post the history of this file ?
RMB on the file and select History, Post that image.