Hi, I am trying to deboss a logo on the surface of a cone, how do I do this without distoring it?
i don't think that can be done in real life. what have you got so far, and what don't you like about it?
Also you could look to the right hand column of this page and check out "More like this." I think your answer is there.
You could use a split line, and project the sketch onto the cone. Showing us what you have and do not like about it (as suggested) would be great also.
Thanks for the tips, but I will just make the logo smaller to minimise the distortion.
Thank you for the help I really appriciate it
Check out the response near the bottom of the thread by Lon Eding.
I think his technique is a solution for your problem.
Retrieving data ...