AnsweredAssumed Answered

Mating round bearing to circular face?

Question asked by Pauliaus Briedis on Aug 20, 2012
Latest reply on Aug 21, 2012 by Pauliaus Briedis

Hello, I am trying to mate face of bearings to thin cut extruded face under a round table.

The bearing might be too large for real life use and the cut might be too deep in this case but that shouldn't influence the mating.

 

So far the closest I have got to was mating the faces tangent each other. I thought mating the second leg bearing face tangent might just solve the problem but I get over defined error.

 

Images of how it should look like are attached, as well as the whole assembly.

 

 

Thank you if anyone have suggestions or even the solved assembly!

Paulius

Outcomes