AnsweredAssumed Answered

Dimensions in Assembly

Question asked by Taylor Kelly on Aug 15, 2012
Latest reply on Sep 15, 2016 by Tom Gagnon

Hi all,

 

I've run into a pretty big problem this morning.  I'm trying to create a fixture around a part that someone has already modeled in the past.  Ideally I would just load this part into my assembly to make sure everything fits, and perhaps use it a bit for dimensions and just general brainstorming; however, when I loaded this part into an assembly sketch dimensions appeared everywhere.  It looks like they may be the sketches used to create the part, but I've looked at a few sketches in th part and they don't match up with the dimensions that show in the assembly.  Any ideas on how to hide these dimensions so my model isn't completely cluttered?

 

I've attached a picture to show what I'm talking about.

Attachments

Outcomes