AnsweredAssumed Answered

Why do I have to delete the tangent constraint and re-create it

Question asked by Dave Klimas on Jul 24, 2012
Latest reply on Jul 30, 2012 by Dave Klimas

I have a 3D sketched spline with the endpoints constrained to two separate offset surfaces and then a tangent constraint to one surface. If I change the offset amount of the surface that the 3D sketch is tangent constained to, the 3D sketch fails. I have to delete the tangent and recreate it. This happens often and is extremely annoying.

 

Any idea why and how I can keep this from happening?

Outcomes