2 Replies Latest reply on Jul 23, 2012 11:49 AM by Randolph Carnell

    'Check Geometry' not recognizing assembly part

    Randolph Carnell

      Hello,

       

      I am having a problem with my geometry in Flow Simulation. The highlighted part is not showing up in the 'Check Geometry.' My flow trajectories are going right through the body as if it is not even there. It is ENABLED under the features design tree but is not listed in the assembly tree in the Check Geometry dialog window. I am completely lost if anyone can help thank you so much in advance.

       

      Randy

      1.jpg