I need copy a sketch that was used for an extrude. I need to take it and make an extrude cut with this same sketch on a different place on the part. Is this possible? Thanks
yes - edit the sketch, ctrl-c, edit other sketch, ctrl-v. Make sure you also copy the dimensions also or the sketch is no longer fully defined and can move all over the place
You can also copy and paste sketch and feature at once. Click on the cut feature in your tree to highlight it, Ctrl+C, click on the desired face or plane, and Ctrl+V. Then edit the pasted sketch to position it.
Or, if you want to drive the new sketch form the original (always identical), create a derived sketch:
Retrieving data ...