Attached is a part and was imported from step file. How will I be able to modify the features within part?
For example of the .250 diameter. What if I want to change the hole size and move to different location.
Jeff, you can use the convert to sheetmetal feature, this will likely help if you want to create drawings for manufacture. If you want to alter the holes I recommend adding a sketch with points at the centres of the holes. You can then fill the holes with a base flange/tab feature and add holes to your specification either using the centre of the holes you marked with the points or at new locations.
feature works may be able to get you an editable part from this. otherwise look in the the help for the "direct editing" features you can use to modify the impoted body.
Fill the hole with an extrude and then add a new hole where you want.
Or Delete Face with Patch option set. Then add a new hole where you would like it to be.
You can try move face (Insert>move)
See the picture below
It has options to offset, translate and rotate
Hope this helps
I like your method and it's convenient to move the locations. But can I change the hole size also? I'm not seeing that option.
Offset the face in the Move Face coomand to change the size.
This video might help what Jeff is pointing to.
Retrieving data ...