1 Reply Latest reply on Jul 2, 2012 7:24 AM by Pradeepkumar Mirajgave

    Mesh pattern and mesh base

    AM D

      Can anyone help me in understanding the mesh pattern shown in below image. Why the element pattern is uniform? Even though the surface is uniform why the elements are having different aspect ratios at different circumferences? I have used both standard as well as curvature based mesh but im getting the same message. Also I wanted to know from which point the mesh generation will start in any analysis(part/ assembly) under SW Simulation. Please help me on the above query.

      1.JPG 2.JPG 3.JPG

       

      Thanks & Regards,

      AMD

        • Re: Mesh pattern and mesh base
          Pradeepkumar Mirajgave

          I have also tried it for the uniform surface, but the aspect ration i got was in the range of 500 at some portion of the body. But you check at the the mesh details, very small percentage of the elements will be having aspect ratio more than 10. This does not affect much to your results. You try with different element sizes and compare the results.