AnsweredAssumed Answered

hole pattern on a corved surface through assemblies?

Question asked by Ryan Hader on Jun 29, 2012
Latest reply on Jun 29, 2012 by Ryan Hader

Hey Guys,

 

I am trying to put some hole patterns from one part through another that follows a curved sketch pattern. There will essentially be 2 hole patterns.

 

the image is shown below. Any suggestions on both the easiest way to do the hoel patterns as well as putting them throgh all pieces? I suppose bringing throm in the assembly s the best way?

 

FAIRING.jpg

Attachments

Outcomes