AnsweredAssumed Answered

Having trouble with Constraints...

Question asked by Chris Bargman on Jun 29, 2012
Latest reply on Jun 29, 2012 by Chris Bargman

I am having this issue with more than one of the modls I am trying to simulate but can not for the life of me figure out to do... 

 

What it all comes down to is I keep getting the "Status code:9" error.  Now I have done quite a bit of searching and it seems that this is more than likley being caused by the contact conditions not being set correctly.  But I guess I cant quite figure out how this works.

 

When I go to apply the contact conditions I apply them to all the surfaces that the program seems to allow me to.  But this is not all the touching surfaces?  So I ran the interferiance check thinking maybe they are not actully touching.  But no,  There are surly more surfaces touching than it will let me constrain.  So why is it only letting me apply contacts to a specific few faces when there are more that are in contact?

 

Any help would be appreciated I am just trying to figure out how this program works...

Outcomes