Is there a way to keep the parts that are not being edited in an assy from changing to transparent? Tried searching the forum, but was unsuccessful at finding anythign.
To set the default transparency to use during component editing:
Mike, you can change this in options > System options > Display/Selection, there is a slider bar for assembly transparency in in-context editing
Thanks all. I must admit I was a little lazy looking through the options as I'm in a bit of a crunch.....
Sorry to resurrect this thread but I couldn't find my answer anywhere else and this is the most relevant thread.
What other setting could cause the "Assembly transparent for in context edit" feature to be grayed out? The transparency feature is disabled and I don't have the option of turning it on or adjusting it.
I am in Large Assembly Mode and all comonents are automatically loaded lightweight. I'm not sure if that matters, but those are the settings I change most recently. Although turning them off doesn't seem to enable the in-context editing transparency feature.
Retrieving data ...