Hi can any one help me drawing this tooth profile in solidworks? I have the following caluclation.

                                                            SPUR GEAR:                           rack                              wormgear

pressure angle                                    14.5                                            14.5                              14.5          

diamertical pitch                                   12 diametrical pitch                    12                                   10    

bore size                                             0.75 inches                              ---------------------------------------

pitch diameter                                      2                                                   ------                                 2

face width                                            0.75                                              0.75                              .6250

length through bore                              1.25                                             -----                                 1.25

hub diameter                                        1.65                                           -------                                   1.62

keyway size                                            3/16*3/32                                  ------                                   -----

outside diameter                                        2.1670                               -----------                                2.25

pitch line to back                                       -------                                   0.667                                   0.312

overall thickenss of rack                          --------                                  0.75

ratio                                                         ------                                       ----                                           10:1

I have been searching for this from 15 days please its urgent