AnsweredAssumed Answered

Custom elbow is not working properly

Question asked by Chris Sparber on Jun 20, 2012
Latest reply on Jun 21, 2012 by Chris Sparber

Hello All--

 

I am stumped.  I am creating a custom elbow and followed the directions from solidworks on the required geometry.  I also ran it through the routing library manager tool, and it is still not inserting into my route properly. The bend radius does not show up in the route like if one was to insert a solidworks elbow.  The elbow also does not rotate properly either because I have solidworks set to increment at 30 degrees and it increments at 90 which is odd.  I have attached a copy of the pipe, elbow, and tee that I have been using for this particular route.  The elbow model only has one configuration which is for .500" steel threaded pipe. 

 

Thanks. 

 

Sincerely,

 

Chris

Outcomes