2 Replies Latest reply on Jun 14, 2012 3:43 AM by Sammy Redshaw

Pattern a plane around an axis

Sammy Redshaw Jun 13, 2012 12:14 PM

Is there a command to pattern a plane around an axis instead of clicking the axis the a sketch to place the plane at the correct angle. Would speed things up for me as creting 14 planes around a axis takes a while.

Re: Pattern a plane around an axis

Jeremy Feist Jun 13, 2012 12:17 PM (in response to Sammy Redshaw)

directly in the plane comand (SW 2012 shown, but I believe this was added in 2011)
Like Show 0 Likes(0)

Actions
- Re: Pattern a plane around an axis
  
  Sammy Redshaw Jun 14, 2012 3:43 AM (in response to Jeremy Feist)
  
  ta thanks couldn't find it in the 2012 help file
  
  Like Show 0 Likes(0)
  
  Actions

Go to original post