AnsweredAssumed Answered

Unfold vs Flat Pattern gives different results

Question asked by David Antanavige on Jun 6, 2012
Latest reply on Sep 22, 2014 by Greg Stone

I have a part that was designed using SW 2012 SP3. When I the flatten feature in SW to unbend a part I am getting different results on the prerimeter than if i unfolded the bent part. Specifical the corner relief is absent in the "flat pattern" version, where the unfold seems true to reality and produces good usuable flat patterns. Any one have any advice? Untitled.png

Attachments

Outcomes