I am doing the very basic and my first sheet metal tutorial. I am stuck where it is asking me to "click Propagate". I can not find the propagate icon anywere. Is this a tool bar butten that needs to be set up? Here is where I am at. This is the built in Tutorial.
Thank you,
Mark
Yes I exited the sketch. That was the step before the instructions said to hit the propagate button. Where should this propagate button be? In the Sheetmetal tool bar or off the part in the drawing space?
The Propagate icon should appear on the edge selected during the Mitre Flange creation.
Hallo Mark,
The function is only active when SWX recognizes a tangential Continue the edges.
There is no extra button to configure
SIegfried
Mark,
As Siegfried mentioned, this icon only apperars with a "tangential continue" see below examples.
Mark,
I had the same problem. You need to right click on the miter flange to Edit Feature, then left click on the bottom edge...you will then see the "propagate icon"
Did you exit the sketch?