I can not run my spur gear bcoz of the gear ratio putting in the Assembly mate, CAN ANY ONE HELP ME on this?
My gear details
Spur Pinion - 18T / OD 50mm
Spur Gear - 24T / OD 65mm
Can't say when the last time I used a gear ratio mate was and I'm on the Mac right now so can't read up on the latest SW mate stuff just now, but it looks to me like you need to set the ratio to 3:4 (where you have 10mm and 15.27mm now).
You could use 18:24 too (18/24=3/4), sometimes it is easier to just enter the number of teeth on each gear, SolidWorks won't care and doing math is what the computer is for after all.
thanks erik, its worked for 18:24 ratio!!!
Retrieving data ...