I would like to simulate a shock test, the subject is a electronics assembly, basically a hard drive and a few parts on a PCB which is fixed with screw hole in the corners.
For example 30g for 18ms with a half sine wave form.
you will have to bear with me as i haven't done much simulation with SW. I have the professional package so i might have missed something obvious.
My vendor said look at the drop test.
Any advice or pointers would be great.
Hi Clive: the drop test is not really applicable since you have specified acceleration and impluse at the fastener locations. So for that case, the Modal Time History should do fine. - Tony
Retrieving data ...