AnsweredAssumed Answered

External References in a virtual part (Sub-Assembly) inside an Assembly.

Question asked by Eddie Pellegrin on May 1, 2012
Latest reply on May 1, 2012 by Eddie Pellegrin

Ok, So I have an Assembly with a virtual part inside of it. This virtual part has external references to my old Assembly outside of the PDM, but I can't break all the refences because I have some parts inside this sub-assembly that I would like to keep linked to the PDM.

 

The references are to some sketch planes that are referenced to some faces in my old assembly, but when I try to update these faces to the faces in my new assembly, I get this message.

 

2012-05-01_0954_001.png

 

But If I break all the references, it will allow me to change it, but I don't want to do this.

Is there a way to break only a few references and not all of them at once?

Any ideas?

Outcomes