I have been trying to convert this part into sheetmetal, but no luck. Can anybody help?
Add a bigger gap in your cut.
Here is a SW2012 file. Sorry I do not have an older version of SW installed here at home. I have SW2011 installed at the office and can re-create my file tomorrow if you are using SW2011.
What version of SW are you using? It would be good to add that info to your forum profile.
Good morning Jeff,
A few other things to take a look at;
1. Change your Auto Relief Cut
2. Add an additional cut at the intersection of the round bend and the top straight side, this will allow the material more room to "Flow"
3. Change the radius
Retrieving data ...