3 Replies Latest reply on Apr 26, 2012 7:25 AM by Scott McFadden

Solidworks EPDM

Srikanth Dugyalla Apr 26, 2012 7:09 AM

Hi guys

please suggest me what is best route to evaulate Teamcenter and EPDM.

Again i am saying i dont want to compare, but can you please tell me what are the advantages if i use EPDM over the Teamcenter .But i don't have Solidworks in my system.I am having Pro-e, so now i am standing on netural plane and i want to take decsion , which will be the best & Use-friendly to use.

Thank's & Reagards

Srikanth

Re: Solidworks EPDM

Scott McFadden Apr 26, 2012 7:12 AM (in response to Srikanth Dugyalla)

Srikanth,
I would start by looking to the right of this thread under the "More Like This" heading.
See if any of those give you results you are looking for.
Plus doing research on this forum.
Like Show 0 Likes(0)

Actions
- Re: Solidworks EPDM
  
  Srikanth Dugyalla Apr 26, 2012 7:20 AM (in response to Scott McFadden)
  
  Hello Scott
  
  Thank's for you qucik reply.
  
  But i could not get you, can you please be more clear on this specific.
  
  Like Show 0 Likes(0)
  
  Actions
  - Re: Solidworks EPDM
    
    Scott McFadden Apr 26, 2012 7:25 AM (in response to Srikanth Dugyalla)
    
    HI Srikanth,
    Look here and just click on the threads listed. They will bring up similar discussions that might give you the answers you are looking for.
    
    Like Show 0 Likes(0)
    
    Actions

Go to original post