The cavity is made up of multiple parts. I’ve tried saving as SLDPRT than using the combine tool but its grayed out.
Thanks for any help
I would try and use the cavity command by making a big block around the assembly then
when you have the cavity within the block take the volume of that.
None of the suggestions seem to work, ether the cavity or combine tool is grayed out or I get an error when using them.
I’ve tried both procedures in these ways,
*assembly saved as part, IGES and Parasolid.
*saved as part then inserted into new assembly
I’ve also tried capped and uncapped
Error each time?
can you attach the original assemby? it is a bit difficult to be sure what volume you need from these surfaces...
won't do it because they are surfaces and not solids
Thanks for the replies, I ended up opening the individual parts, capping them and totaling the mass that way. Don’t know why I didn’t think of that sooner
I am glad you figured out a way. Ironic I was just going to create a cavity model for you as I saw you response come in.
Retrieving data ...