Could any one tell me how to write an equation to describe that
Status of Extrude1 = Status of Extrude 2 , what I mean that if extrude 2 suppressed then extrude 1 will be suppressed
from my practice, use should use the "design table".
since it base on excel you can make one equal the other.
see photo with equation
if yo ureally want to use equations you may try
$State@Extrude1 = $State@Extrude2
I would start with the design table to get the syntax correct. It might be $state@boss-extrude1 ect...
In SW2012 you can use suppressed and unsuppressed as variables. One thing you may try is creating a sketch and putting a dimention on it and create an equation that relates the state of suppression to weather the sketch dimention is greater or less than 1 for example. this dimention can then be controlled by an outside influence too. Hope this helps. Here is a screenshot of useing my sketch method
thank you very much
I tried this but it didn't work
Retrieving data ...