1 Reply Latest reply on Apr 16, 2012 1:49 PM by Lenny Bucholz

    Rounding imported STL

    Baldwin Goodell
    Baldwin Goodell Apr 5, 2012 4:54 PM

      I was able to simplify my mesh in Meshlab and import into SW as a surface.  The resulting SW part has a convex curved surface.  I then created a mating part that has a concave surface.  I sent it to the machinist but they are saying that they can't make it b/c every small face needs to be filletted.  When I select all of the edges to be filleted SW does not seem able to complete the task.  I tried to attach a jpeg of the part but it was very slow so I will try again later.  Any suggestions?

       

       

      Also how do I tell if I have scan to 3d?  I have Solidworks Professional 2011 x64 SP4.  Thanks, Baldwin