AnsweredAssumed Answered

Error messages when dimensioned to sketch entities in drawing

Question asked by Glenn Schroeder on Apr 5, 2012
Latest reply on Aug 14, 2012 by Glenn Schroeder

I'm pretty sure this started when I went from SW2010 to SW2012.  When I place a sketch entity in a drawing view, restrain it, then place a dimension, I get these error messages.  In the picture below I placed sketch lines to show ground level on this curb (I could have placed a surface in the model, but of course surfaces don't show up in section views).  The same thing happened when I placed a sketch point coincident with the top edge and right face so I could place the 8" dimension.  I don't think it hurts anything but it is annoying.  Any ideas?

 

sketch error.png

Outcomes