AnsweredAssumed Answered

Origin not coinciding between sub assy and main assy

Question asked by Ray Luck on Mar 20, 2012
Latest reply on Mar 21, 2012 by Deepak Gupta

Hello Forum,

 

I know this has been an issue in previous releases of SW but I'm getting it in SW2012 SP2.0 x64 (Also running EPDM 2012 SP2.0).

 

When I insert a sub assembly into my main assembly, the sub assembly will hover (like it always does) until the cursor moves over to the green tick where it snaps into place (0, 0, 0). However, as soon as I click on the tick or press enter, it moves and the origins are out.

 

Has anyone had similar experiences with 2012? I've never had this happen before.

 

Cheers,

 

Ray.

Attachments

Outcomes