heey guys !
so i'm kinda new to this forum so i still need to find out wich section is what ! but i think i posted this in the right one
so here is my question , i'm currently busy with making a few logo's in solidworks and than print them in our 3d printer on school
but on my current logo of the artist called feed me i get an error and i dont know what it meens !
i can't extrude and i already tried fixen the sketch but i can't find any errors !
sorry for my bad english !
hey wayne, just wondering,
can i not open the attached file because its saved with a newer solidworks than what i am currently running?
Anthony Macke wrote:
can i not open the attached file because its saved with a newer solidworks than what i am currently running?
Yes.
That is correct - his file is in a newer version than you are running and your version will not open it.
WT
In the hand sticking out from body there is two arcs overlapping each other in between the fingers, use the trim entities tool to correct this and it extrudes just fine.
you have a couple of arcs crossing each other on the right hand as you look at it...just trim off and it works....
thanks guys ! my question is how did you find it ?
You can zoom in on it or press G (default magnifying glass) for a closer look.
The best method is to use the tool, "Check Sketch for Feature". Tools -> Sketch Tools -> Check sketch for feature. Select Base Extrude from the list of features. This will highlight the problem geometry.
Or follow my reply. Basically the same thing except it tells you what the problem is when you try to extrude it.
WT
You have a self-intersecting contour - just trim it off. If the little guy is looking at me, it's the bottom of his left hand. If you try to extrude and it tells you that it can't, look at what is highlighted in the graphics area.
WT