Anyone using spools with success? I have this run and i need to make a spool out of it. but i keep getting error about spool not being contiguous. all the lines are connected and the parts highlight when i select sketch segments. thoughts?
Is the pump from your assembly in the same route as all the other components?
I.E. does the pump have it's own CPoint in the route you are editing?
yes there is one route assembly and all components are part of it. I did a test and re-created a fresh one and it works the way it should. I dont see what could be the problem
Perhaps I'm misunderstanding, I do hope so, but is your intention to have 1 spoolpiece of as well the bit of piping on the one side of the pump and the elements on the other side of the pump?
yes i would like to since the pipe where the valve goes has a penetrate feature and spools are not supported with penetrate.
I am having a similar problem. I am doing the piping for a chiller skid. I have the piping all built up, and I am using few weldelets. I defined the spools for the pipe, but I want to add the weldelets to the spool it gives me the same error. In few spools the weldelets added perfectly but in other spools it did not,
Retrieving data ...