everytime i close and re-open the measure dialog box its never where i left it. not a big deal, just annoying having to pull it from one screen to the other everytime i use it.
so my question is, what do i have to do to get my measure dialog box to stay where i left it?
it stays were you left only in the current session you are in, if you close SW it goes back to its original possition, then you have to move it again it will stay till you close again
sorry didn't see you are splitting screens
The Measure dialogue box should remain where it was placed between sessions. It does on my SW12 install and has on several other versions.
Ok, i enabled the nView desktop manager, and messed around with the different settings under the "windows" tab, "dialog box repositioning" section and the dialog box is still moving back to its previous location after i close and re-open it. i matched my settings to the screen shot in the suggested solutions and its still not working.
im going to continue messing around with the nView desktop manager settings to see if i cant get it to stay put.
the thing i dont understand is that the measure dialog box is the only one in solidworks that wont stay where i leave it. the open dialog box, save dialog box, mass properties dialog box all open up in the same spot i left them. the measure dialog box is the only one (that i have noticed) that wont.
i have discovered that if i set my left monitor to be the main display rather than the right monitor, it works fine
i have discovered that if i set my left monitor to be the main display rather than the right monitor, it works fine