AnsweredAssumed Answered

How to make this as sheet metal feature and not flex?

Question asked by Josef Snabb on Feb 25, 2012
Latest reply on Feb 27, 2012 by Kelvin Lamport

Hello guys.

 

I have roll bended sheet metal part, made by a single line and than made to a Base Flange (sheet metal). I want to make a cut out on
this but in flattened mode, how to I do this? (Because making the cut when it is unflattened make the cut out angel wrong)

 

I´m aware of that this kind of part can be made with the Flex command - making the cut and than flex it it but it doesn´t result well on this part, see picture.

 

I have done searching on this forum about this but didn´t fin my answer.

 

With kind regards

 

Josef

Attachments

Outcomes