I Cannot seem to get the mitre flange working properly with sheet metal with sw 2012 sp 2, has any one else had the same problem???
I just tried a simple test and it seemed to work fine. Can you post a sample of your issue?
ok it works fine when i sketch on the end of a face but not when i convert a sketch to the end of a face
That's pretty weird for sure. If I start deleting the on edge relations, I can get it to work with only one of them left. Or delete the last line segment and it works. Add an additional one and two bends fail to work. Or delete all the relations and leave the sketch lines - works.
Make sure you send this in and let us know what you find out.
Am I missing something? The part provided has the sketch on the end that is converted from the center sketch and it works fine.
What I saw was that the flange that was created from the converted sketch would not put a bend in the middle, only the outside bends were there. Are you seeing the part fully flatten properly?
See it now, I was just looking at the feature working or not. That is really odd. Looks like a bug for sure.
You create this model through straight line for the sheetmetal you should provide some (minium bend radius) Bend radius
Then only you get the correct flattern.
I also update the model & It get flattern..
See the screen shot
This issue is now attached to an SPR# 588333.
Retrieving data ...