Ok, I know this has always been a problem to some extent, but 2012 is the worst yet for this. The only way I can get it to release memory is close solidworks and open it again. Pic below shows solidworks with nothing open!
Has anyone else seen this with 2012?
yes sir, another of my complaints that have been around way too long, large file sizes, delays in editing sketches, lag in rotations (which by the way is fine if I first select a surface or edge then rotate...not tooooooo crazy)...etc, etc.
Even with SW being one of the easiest platroms to learn and adapt to, these other issues are large reasons I dropped 25 seats of maintenance and will not be upgrading until at least SW2013....unless we swithc CAD systems by then
Had the same problem in SP1.0 but now SP2.0 seems to solve the problem for me.
Maybe I should try re installing sp 2, or wait for sp 3.
Retrieving data ...