AnsweredAssumed Answered

Reversal connectors in ribbon cable flatten route

Question asked by Tomasz Siembida on Feb 15, 2012
Latest reply on Nov 3, 2016 by Rich Harder

When I designing ribbon cable and then try to flattening cable, connectors turn around at 180degrees. Sometimes connectors are ok. but 1st wire change position to the last. Have you ever had this problem with ribbon cables in Routing?

 

I use SolidWorks 2011.

 

I attach two pictures showed my problem.

 

This is model of my ribbon cable:

3D_model.jpg

and flattened cable:

Flattened_cable.jpg

Best regards

Tom

Outcomes