2 Replies Latest reply on Feb 13, 2012 3:56 AM by Raghavendra Bhagwan

DXF output fails sometimes

Chad Draxler Feb 10, 2012 4:24 PM

Our output dxf task sometimes fails becasue "does not meet the conditions of any category" when the only condition is that it ends in .dxf

The task works about 95% of the time, and again since the only condition of the category is that it ends in .dxf which is a part of the task itself, how can it not meet the condition of the category...?

Any help would be appreciated.

Re: DXF output fails sometimes

Wayne Matus Feb 10, 2012 4:42 PM (in response to Chad Draxler)

For testing purposes, have the task also create a copy of the dxf outside the vault. See if it creates this copy when it fails to create the one in the vault. If it does create the dxf outside, try manually adding this file to the vault.
Like Show 0 Likes(0)

Actions
Re: DXF output fails sometimes

Raghavendra Bhagwan Feb 13, 2012 3:56 AM (in response to Chad Draxler)

Chad,

Is the task running in a specific machine or executed from where it is triggered ?
Like Show 0 Likes(0)

Actions

Go to original post