Skip navigation

Log in to create and rate content, and to follow, bookmark, and share content with other members.

AnsweredAssumed Answered

Can't find Cams

Question asked by Hany Abdelkader on Feb 7, 2012
Latest reply on Feb 7, 2012 by Hany Abdelkader

Like • Show 0 Likes0
Comment • 5

Can any one help me finding where should the cams be in the toolbox ??

Thanks

Andrew Hall Feb 7, 2012 2:33 PM

Correct Answer

Go to tools--add ins and turn on both the "SolidWork Toolbox" and "SolidWorks Toolbox Browser"

See the reply in context

No one else had this question

Outcomes

5 Replies

Andrew Hall Feb 7, 2012 1:50 PM
Mark Correct
Correct Answer
Like • Show 0 Likes0
Actions
Scott McFadden Feb 7, 2012 2:06 PM
Mark Correct
Correct Answer
Hany,
These cams?
Like • Show 0 Likes0
Actions
- Hany Abdelkader @ Scott McFadden on Feb 7, 2012 2:29 PM
  Mark Correct
  Correct Answer
  thanks all , but my question is I can not find it in the menu as the pic is showing , the menu is always showing just the conifguration , even when I configure the toobox it is not showing it
  Like • Show 0 Likes0
  Actions
  - Andrew Hall @ Hany Abdelkader on Feb 7, 2012 2:33 PM
    Unmark Correct
    Correct Answer
    Go to tools--add ins and turn on both the "SolidWork Toolbox" and "SolidWorks Toolbox Browser"
    Like • Show 0 Likes0
    Actions
    - Hany Abdelkader @ Andrew Hall on Feb 7, 2012 2:34 PM
      Mark Correct
      Correct Answer
      thank you much it is working
      Like • Show 0 Likes0
      Actions

Recommended Content