1 Reply Latest reply on May 16, 2006 7:23 AM by

    dxf imports to SW

      When you d your import, make sure you set the option to import the geometry 'as a 2D sketch' instead of as 3D curves (unless you're bringing in a solid model). You're presented with that option on the same page where you specify import units.
        • dxf imports to SW
          Hi, I need to convert a Dxf file to SW as a part and then use it in a assembly. The problem isn't importing it into SW, but that the line in DXF file is then converted into curves, and then regular SW parts can't be mated to the "reference "part. I would like to know how to overcome this problem, as it is vital for the part be be lines for what i wnt to do.

          Thanks,
          Jacques jlerm@tricom1.co.za