AnsweredAssumed Answered

Mass properties error?

Question asked by Elise Moss on Jan 26, 2012
Latest reply on Jan 29, 2012 by Scott McFadden

I needed to calculate the volume of a box to make sure it met UL requirements.


So, I created a quick assy of the top and bottom cover and then went to mass properties and looked at the volume.


The volume did not appear correct.


So, I ended up taking the internal measurements from face to face and calculating using height*length*width.  The difference was pretty substantial.  Because the numbers SolidWorks gave did not meet UL and my hand calculation did.


I am wondering if others have also experienced this...