AnsweredAssumed Answered

Request for Suggestions for bend allowance config with 5052-H32 .125 AL

Question asked by Bob Hanson on Jan 12, 2012
Latest reply on Jul 23, 2012 by Bernie Daraz

Hello All,


Can you please identify what you suggest when calculating the bend allowance for .125 Aluminum Type 5052-H32?


Whether it is K factor, bend allowance values, table, etc and what works for you.


We are using brake presses for this with tooling radii of .008, .090 and .125 as typical.


Thanks for any help


Bob Hanson