AnsweredAssumed Answered

Closed rolled sheet metal corners function in SW 2012?

Question asked by Gary Hood on Jan 10, 2012
Latest reply on Feb 16, 2012 by Gary Hood

I've seen a lot of discussion here about how closing the corner of two rolled flanges isn't possible in older versions of SW.  Any improvements for 2012?  Just installed 2012, but haven't figured it out yet.  I found this discussion from Dec 2010, with a good picture of our same problem. https://forum.solidworks.com/thread/39401

 

SinkTub_RolledCornerIssue.jpg

 

Thanks

Outcomes