I am not able to take out brokenout section from exploded view. Please some one guide me.
What error are you getting??
I not getting any error, i want show few of the part brokenout in exploded view.
So what's troubling you then. Create the broken view as required and use section scope to define which parts you don't want to cut.
Are you having issues with the depth of the broken out section? If so just pick an outline edge
of an existing component and see if that gives you what you are looking for. Remember to do this
after creating your spline outlining the area you want broken out.
We have exploded configration in the assembly, while genearting drawing I want to show few of the parts brokenout setion, If i take it brokenout section from exploded view, again all the parts goes to assembled while using rebuild option.
Right click on the View and select properties. The make sure "Show in exploded state" is checked.
Seems as if the last time I tried (SW2011), SW doesn't support this function. I may be mis-remembering tho.
Yes, it seems as if it should be able to.
Ok, got a chance to open SW up.
Is the view you're tryi ng to create the broken-out section in an Iso or some other view (i.e. not Front, Top, Right, etc..)? It is in these instances where you cannot create the Broken Out Section.
If I do a Broken out section and then switch the view to Dimetric, I can fake it out a little, but any modifciations seem to mess it up.
Message was edited by: Alan Stoldt
I'll have to check it and confirm but AFAI remember I was able to do it.
Alan has some good points that I was going to mention.
These types of views do not lend themselves to broken out sections too well as you are finding out.
You might be best creating a section cut in the assembly and save that as a special configuration
then import that config in a view in your drawing.
Retrieving data ...