1 Reply Latest reply on Jan 9, 2012 1:43 PM by Glenn Schroeder

    Relocation Origin Of A Drawing View

    jacob may

      I know when you first insert a drawing view the origin is dead center. I am not too for sure if this can be done or not but im going to ask anyways. I am wanting to put the origin at the very bottom center of the view. Is this possible? If so how is it done? Thanks in advance

        • Re: Relocation Origin Of A Drawing View
          Glenn Schroeder

          Jacob,

           

          I'm not sure I understand your question.  It's in the Drawings and Detailing section so I assume you're referring to a drawing view in a SW drawing.  If so, then the origin of the drawing view is in the same place as the origin of the model.

           

          If you're referring to the origin location when you start a sketch in a part or assembly, then putting your cursor above it and rolling the mouse wheel a couple of clicks will move it down but I don't know of a way to have it there automatically.  I like to keep the origin centered on my models whenever possible so I like it centered.

           

          If this doesn't answer your question please explain further.