I'm not quite sure how to make this part on Solidworks so I was wondering if anyone could help me or give me any advice:
The inside diameter of the circle is 3.5mm, the outside circle 6.5.
Thanks once again guys!
How about using the sweep function or even revolve.
Sweep the main body .... straight plus the eye
Revolve-cut to create the sharp point
Sweep-cut the thread
I would download it at www.mcmaster.com.
Good morning Harvey,
The way I would do this part is;
The way the part is showing, add a sketch in the top plane with the profile of the eye bolt, close the sketch
Add a new plane at the location of the point, add a sketch in the new plane, the profile would be a circle, close the sketch
Highlight both sketches and add the sweep extrude features, add a champer for the point, than add a tapered the helix.
Retrieving data ...