0 Replies Latest reply on Dec 28, 2011 12:36 PM by robert dattilo

    Cutlist bogs drawing

    robert dattilo

      Hello;

       

           I have a part that is a weldment built with a 3-d sketch, some configurations etc., along with that there's a drawing that has a couple sheets.

      I wondering what's going on; everything runs smoothly, but when I add the cutlist to the drawing, it bogs down really bad. What took around

      a minute to re-build/save etc., then takes around 6/7 minutes, and also becomes very unstable. Anybody have an insight to what might be

      happening?

       

      Thks, in advance;

       

      Rob_D  SW 2011