AnsweredAssumed Answered

How to set "Thickness" to 1 place decimal

Question asked by Mukesh Prasad on Dec 17, 2011
Latest reply on Dec 18, 2011 by Deepak Gupta

I have a sheet metal part that was started out as the unit being 3 places but I changed it after the base flange was created. I now wanted to link the material thickness to a property to show up in my drawing title block. As you can see the thinkness is showing up as 3 places decimal. How can I change this to one place without manually back spacing the last two digits?

Attachments

Outcomes