AnsweredAssumed Answered

Reset or rotate plane

Question asked by R N Rondeau on Dec 16, 2011
Latest reply on Dec 16, 2011 by R N Rondeau

I can't seem to find the answer in the forum...

I've got a thin rectangular part that has features along one edge.  When the TOP orientation view is selected, the part's face is shown correctly but it's rotated 180, i.e., the features should be along the upper edge of the part but instead they are on the lower edge.   I tried a few of suggestions from this forum, but I guess they weren't quite for the same issue.

 

THank you,

 

Roger

Outcomes