2 Replies Latest reply on Dec 16, 2011 7:35 AM by Deepak Gupta

    section size

    Mark Greenwell

      Hi,

       

      I am going to create a sketch and save it as a weldment profile.

       

      The section is a 600 600 x 40 square hollow section. (Jumbo Section).

       

      The profile is no bother, what I am trying to find out is what are the inside and outside corner radius for this size section.

       

      We have a section table which only goes up to 400 x 400 x 16 which shows inside radius of 32mm and outside radius 48mm (which is 2 & 3 times thickness).

      So I could make this section radius 80mm & 120mm, however I cannot find any info to say this is correct.

       

      The smaller the section required then this 2 & 3 times formula changes so for example a 220 x 220 x 6 will ask for 12mm outside 6mm inside (1 & 2 times thickness).

       

      So does any one have a metric chart / or know showing Jumbo section internal / external radius.

       

      Thanks

       

      Mark (Solidworks 2012 sp1)